You need enough heat to get the joint fast but not too much heat. The key to soldering them is to have a good iron like the Weller TCP series. Too long and the collet strain relief doesn't work. Includes a low-thermal (LEMO) connector and a strain relief. Too short and it is imossible to assemble. Barrel Adapter 2635, 2635A, 2636, 2636A, 4200-SCS, Triax interconnect. The length is specified in the catalog for that particular connector. Very carefully strip and tin the conductors. (Learned that lesson young from my aerospace engineer father!) The nuts require metric wrenches of the right size. Heat shink might fill it but it is best to do it properly. Too big and you won't have any strain relief on the cable. Too small and you will never assemble the connector. There are options here and you need to measure the cable diameter and specify the exact proper collet. One area that is important is that the cable clamp collet must be sized appropriately for the cable diameter. People that can't solder an XLR properly should not consider something small like the LEMO! Thank you John for your exhaustive explanation. Good luck, and remember, lots of patience and you'll be okay. The tips of a small pair of those can work to fit into the notches of the collet to tighten it against the strain relief collar. Instead of that, you can get by with what I call "nibblers" which are the little thin side cutters for trimming wires flush with a circuit board, etc. The pliers you need is a small pair with two tiny round tips such as used for a spring keeper of the type that has two holes that allow you to expand the spring. With the screw-on type connector, you'll need the proper tool to tighten the collet down onto the collar. Try a few single strands (not crossing each other, which would add to the thickness), and you should be fine. You must take your time and carefully trim and fan the strands so you don't have a thickness that the collar won't fit against. When it's tightened down, they'll make good contact from the pressure. I use the metal strain relief collar and trap strands of the shield under it. Could you explain the best way to connect the cable shield to the shell?Do you have to solder or you simply lock the cable shield in the shell?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |